Close-up: The V1143 Beatle Control Panel

The Beatle had three channels on the upper control panel, while the tremolo, repeat percussion, and reverb controls are located below these controls. The American amplifiers had their model names' silk screened onto aluminum escutcheon plate as seen above.

Channel one offers a wide range of tonal control with both full bass and treble response. A "Top Boost" switch accented treble frequencies. The "distortion" or "fuzz tone" circuitry was also in channel one, but there was no control panel switch to actuate this effect. The "fuzz" was turned on using the remote foot switch. Other available effects in channel one were reverb and tremolo.
Channel two utilized a high pass filter circuit to effectively reduce bass response. The owners manual that came with these amplifiers suggested that channel two had "top boost" circuitry. This seems a little humorous as channel one actually has a switch labeled "Top Boost." Channel two is very trebly and thin when compared to channel one.

MRB (mid range boost) can be found in channel two. MRB used a .5 mh coil along with three different value capacitors and a small preamp to boost frequencies 6 db selectively at 450, 600, and 750 hz. A three position rotary selector switch for frequency selection was on the lower control panel, and a rocker switch on the upper panel engaged the effect. MRB could also be actuated from the included pedal by depressing...and holding down...a momentary foot switch.

Reverb was also available for selection to channel two.

Channel three had only two controls, Volume and Tone -X. This was the "bass guitar" channel.

Tone-X was a tone control that replaced the normal bass and treble control. Tone-X was a sweepable EQ control that offered about a 6 db boost from approximately 50 hz (control counter clockwise) to 300 hz (control clockwise). Most people I knew that played bass through a Beatle head used Channel One.

The rotary power switch had three positions. When rotating the switch from "Off" to "Standby," a green pilot lamp illuminated and the amp was turned on. The speakers were muted. In the "Operate" mode, the speakers were introduced to the circuit.

One wafer of this power switch frequently broken, and the standby funtion is non functional. There are no replacements available for this switch.

North Coast Music offers the original green and red pilot lamp assemblies for this amp. Click here to be taken to the web page in the North Coast Music web site that offers these pilot lamps.

The tremolo effect is only available in channel one.
Repeat Percussion is basically "extreme tremolo." Rather than pulsing the volume of the input signal at varying speeds and depths of amplitude as done with tremolo, Repeat Percussion clicked the signal off and on in varying speeds. This effect was borrowed from a Thomas home organ model that used this effect to simulate the strumming of a banjo. Repeat Percussion was used in the vocals at the ending of "Crimson and Clover" by Tommy James and the Shondells.

Repeat Percussion was unique to the V1143 Beatle amp, although it was also sold as a separate battery powered accessory.

The rotary MRB switch selects between three "center" boost frequencies, 450, 600, and 750 hz. The MRB effect is engaged by either depressing the rocker switch in the channel two area of the control panel, or by depressing the MRB foot switch on the remote floor pedal.
Reverb was assignable to either Channel One or Two. A Blend control increased the amount of reverb in the output signal. A two spring Accutronics reverb pan was utilzed in the reverb circuit.
Flipping the switch for the "Tune-E" circuit played an audible "E" note to help tune your guitar. The loudness of the "E" tone is adjusted using the volume control on the bass channel.
Anyone who used a Thomas amp head back in the sixties will have a story about the "Line Reverse" switch. These heads did not have a grounded AC plug, so you could get a searing shock when your lips hit the microphone while your hands were on your guitar strings. Flippng the "Line Reverse" switch eliminated that shock. The amp was quote normally a little quieter when the "Line Reverse" switch was in its proper position, as well.





North Coast Music manufactures many replacement and restoration

parts for the Super Beatle under license from Vox. These parts are
available exclusively at North Coast Music. Some are shown below.




3_Footer




The VOX Showroom!


Photos and editorial content courtesy Gary Hahlbeck, North Coast Music


Any and all material presented herein is protected by Copyright.
© 1998 - 2024 The Vox Showroom and North Coast Music, all rights reserved

The images and editorial content in this web site may not be copied or reproduced
in online auction sites such as eBay, Reverb and Craig's List. Sellers may provide a link
to the Vox Showroom web site if they wish to refer to this copyrighted material.


URL: http://www.voxshowroom.com/us/amp/beatcont.html